REN I N . COM
1
Make Measurements.
Measure down 47 ½" from the bottom of the track and make a small line on the edge of the door near where the handle will be installed. Note 1: Please ensure your door is fully installed and remains on the track before installing Renin's Easy Latch. Note 2: Latch Handle Assembly is located on the inside of room requiring privacy
2
A) Position the bottom edge of one (1) T bracket on the line, centered on the edge of the door and mark a hole location in the center of each slot. B) Position the top edge of the door handle assembly at the line made in Step 1, ensuring the small lip is located on the edge of the door and mark the 4 hole locations with an awl. Note: A nail will also suffice. C) Position the top edge of one (1) T bracket 5/8" from the top of the door edge, centered on the door side and mark a hole location in the center of each slot.
B
A
C
Small Lip
3
A) Using a 1/8" drill bit, drill all the marked hole locations ¾" deep, including the front door assembly holes. Note: Do not drill deeper then ¾" and/or do not drill through the door.
| 3 Installation Instructions
Powered by FlippingBook