Garden-Aire Sliding Patio Doors Elevation Charts
Garden-Aire Rectangular Transoms
Garden-Aire Sliding Patio Doors | Rectangular Transoms
3'-7 1/2" 3'-5 3/4" 34"
2'-10 3/4" 2'-9" 25 1/4"
5'-2 1/4" 5'-0 1/2" 52 3/4"
3'-4 3/4" 3'-3" 31 1/4"
4'-4 3/4" 4'-3" 43 1/4"
6'-2 1/4" 6'-0 1/2" 64 3/4"
6'-8 1/4" 6'-6 1/2" 70 3/4"
8'-2 1/4" 8'-0 1/2" 88 3/4"
U.D.
R.O.
G.S.
2910
3310
3610
8014
2914
3314
3614
6014
6614
5014
4314
8016
2916
6016
6616
4316
5016
3316
3616
8018
2918
6018
6618
4318
3318
3618
5018
8020
2920
3320
3620
6020
6620
4320
5020
6026
6626
8026
2926
3626
3326
4326
5026
Operation is viewed from the exterior. Standard operation is shown. Please specify if other operational configurations are needed.
U.D. = Unit Dimension • R.O. = Rough Opening G.S. = Glass Size (Glass sizes are shown per panel.)
Dimension Calculations
Elevation charts provide wood unit dimensions for units with the standard 1-15/16" brickmould. Below are the calculations to determine the frame size of units with brickmould.
Width Height
1-15/16" brickmould; U.D. to F.S.
-2 1/4"
-1 1/8"
3-1/2" flat or profiled casing; U.D. to F.S. -5 3/8" 3-1/2" casing and backband; U.D. to F.S. -6 7/8"
-2 11/16" -3 7/16"
F.S. to Panel O.S.M.
+1/2"÷2
-2 3/4"
Panel O.S.M. to G.S. (standard stiles & rails) -5"
-4 11/16"
G.S. to D.L.O.
-1"
-1"
Note: Clear opening dimensions can be found on pg. 199-200. Contact supplier for 4-wide Garden-Aire dimension calculations.
F.S. = Frame Size • G.S. = Glass Size • O.S.M. = Outside Measurement D.L.O. = Daylight Opening • U.D. = Unit Dimension
NOTE: All measurements are nominal. Elevation charts are not to scale. Rectangular transom units are sash set as standard. The units shown are stand-alone units. Adjustments may be required when stacking over other units; adjustments will be made in the factory. Divided lites are optional. The configuration shown for a single panel is typical for each panel. Some installation procedures will require a larger rough opening than noted (i.e. installations utilizing our installation clips), therefore, you may need to increase the rough opening size accordingly. Rough opening gaps may be increased up to a maximum of 1/2" on all sides and still be within good practice guidelines. For rough opening recommendations, see pg. 194. Additional and the most current drawings are available at www.kolbewindows.com .
Kolbe Windows & Doors 146
Powered by FlippingBook